ITEM #1 – PILLAR MK-20 INDUCTION HEATING POWER SUPPLY

Design Features Include:

1. 20 kW, Output Frequency 235-440 kHz
2. 208-240 V, three phase. 50/60 Hz, 29 kVA
3. Digital timer with enable switch.
4. Main line circuit breaker
5. Diagnostic fault lights for voltage, current, high frequency, low frequency, water temperature and pressure.
6. Ten (10) turn power potentiometer.
7. Illuminated Pushbuttons for Heat On, Heat Off, and Reset
8. Analog meters for monitoring DC voltage, DC current and frequency.
9. Isolation load matching output transformer.
10. 24” deep x 23” wide x 54” high, Weight 440 Lbs
11. Requires 3.5 GPM with a minimum differential pressure of 30 PSI protected by a differential pressure switch
12. Maximum inlet pressure of 100 PSI
13. Inlet water temperature range 680F to 950F trip point with thermal switch protection
14. Configurable for remote start, interface and external power control
15. 0-10v or 4-20mA instrument input for external power control from customer controller (other configurations available upon request)
16. Dry contact closures for Ready, Heat On, and Fault conditions for customer interface

Net Price for One (1) (Value New $42,140)  ....................................................................... $21,000

ITEM #2 - DUAL TIMER POWER CIRCUIT        

One (1) Dual Level timer and power control circuit allowing ramp and soak capabilities to the work piece from the output of the power supply.  An additional timer and 10 turn power potentiometer is mounted in an external enclosure attached to the power supply.